Filter
Top Products
Airport Systems
SG-60 High Intensity Strobe System 2-23 Manual EPM-00000019 Rev A
9. The power wires should be spliced together using split bolt connectors.
The data wires should be spliced together using Scotch® Twist Lock
connectors. After splicing, ensure all wires are secure by pulling on each
wire. Wrap each connection with at least 6 wraps of Scotch 33+ tape or
equivalent for moisture protection. All connection ends should be located
in the upper corners of the junction box with all closed end of the
connector pointing up. See Figure 2-6, Page 2-19 for reference.
Note: The Master Controller can operate from a different AC voltage than the
Flashheads if desired.