Filter
Top Products
314
Selection of operation mode and operation location
(1) Operation mode basics
(2) Operation mode switching method
⋅ The operation mode is to specify the source of
inputting the start command and frequency
command of the inverter.
⋅ Basically, there are following operation modes.
External operation mode: For inputting start
command and frequency command by an external
potentiometer and switches which are connected
to the control circuit terminal.
PU operation mode: For inputting start command
and frequency command by operation panel (FR-
DU07), parameter unit (FR-PU04/FR-PU07) and
RS-485 communication with PU connector.
Network operation mode (NET operation
mode): For inputting start command and
frequency command by RS-485 terminal and
communication options.
⋅ The operation mode can be selected from the
operation panel or with the communication
instruction code.
REMARKS
⋅ Either "3" or "4" may be set to select the PU/external combined operation, and these settings differ in starting method.
⋅ In the initial setting, the stop function by of the PU (FR-DU07/FR-PU07) (PU stop selection) is valid also in other than the
PU operation mode. (Pr. 75 Reset selection/disconnected PU detection/PU stop selection. Refer to page 305.)
REMARKS
⋅ For switching of operation by external terminals, refer to the following:
PU operation external interlock signal (X12 signal) page 318
PU-external operation switch-over signal (X16) page 319
PU-NET operation switchover signal (X65), External-NET operation switchover signal (X66) page 320
Pr. 340 Communication startup mode selection page 321
Network operation mode
Network operation
mode
External
operation
mode
PU operation
mode
Personal
computer
Personal
computer
Operation
panel
Programmable controlle
r
Potentiometer Switch
RS-485
terminals
Inverter
Communication
option
External terminal
Personal
computer
USB
connector
PU
connector
Switching through the network
Switch to the Network operation
mode through the network.
Switch to External
operation mode through
the network.
External operation
Switching with the PU
Press on
the PU to light
Network operation PU operation
Network operation PU operation
When "0, 1, or 2" is set in Pr. 340
When "10 or 12" is set in Pr. 340
Press on the PU to light
Press on
the PU to light
Press on the PU to light