Filter
Top Products
1. FUNCTIONS AND CONFIGURATION
1 - 9
1.7 Configuration including auxiliary equipment
POINT
Equipment other than the servo amplifier and direct drive motor are optional or
recommended products.
(1) MR-J3-100B-RJ080W or less
R S T
Servo amplifier
MR Configurator
Personal
computer
Line noise
filter
(FR-BSF01)
Magnetic
contactor
(MC)
Regenerative option
Power factor
improving DC
reactor
(FR-BEL)
Servo system
controller or Front axis
servo amplifier CN1B
Rear servo amplifier
CN1A or Cap
Junction
terminal
block
(Note 3)
Power supply
(Note 2)
(Note 2)
CN5
PC
L
11
L
21
P1
P2
(Note 1)
Battery
MR-J3BAT
L
1
L
2
L3
CN3
CN1A
CN1B
CN2
CN4
(Note 1)
Absolute
position
storage unit
MR-BTAS01
Direct drive motor
W
U
V
Molded-case
circuit breaker
(MCCB) or fuse
Note 1. The battery (option) and absolute position storage unit (option) are used for the absolute position detection system. (Refer to chapter
9.)
2. The power factor improving AC reactor can also be used. In this case, the power factor improving DC reactor cannot be used. When
not using the power factor improving DC reactor, short P
1
and P
2
.
3. A 1-phase 200V to 230VAC power supply may be used with the servo amplifier of MR-J3-70B-RJ080W or less.
For 1-phase 200V to 230VAC, connect the power supply to L
1
L
2
and leave L
3
open. Refer to section 1.2 for the power supply
specification.