Filter
Top Products
MNA1MLSDM00EN, V2.01, 07.2009
PAS4•S 4 Installation
Portal axes with ball screw drive 53
Gearbox mounting only
A flange plate (1) is required if the gearbox does not have its own flange.
̈ Mount the flange plate to the gearbox with the 4 screws.
Verify that the flange plate has even contact.
̈ Place the gearbox onto the motor adapted plate with even contact.
Secure the gearbox to keep it from falling down.
̈ If the gearbox has a parallel keyway, align the keyway and the slot
of the clamping hub.
̈ Fasten the gearbox with the 4 screws and washers.
̈ Remove the screw plug in the hole at the side of the motor adapter
plate.
̈ Tighten the screw of the clamping hub through the hole with the
tightening torque specified in Table 4.2.
̈ Close the hole with the screw plug.
Please refer to the gearbox manual for mounting a motor to
the gearbox.
1