Filter
Top Products
MNA1MLSDM00EN, V2.01, 07.2009
PAS4•S 6 Diagnostics and troubleshooting
Portal axes with ball screw drive 65
Table 6.2 Tightening torques clamping plate
Prerequisites See chapter 7 "Accessories and spare parts" for suitable spare parts.
You need a set of Allen keys and a torque wrench with hexagon socket
and a pair of tin snips.
Procedure Carry out the following steps on both ends of the carriage / linear axis.
2 set screws at the cover strip clamp fixate the clamping plate below and
the cover strip.
̈ Loosen the two set screws.
̈ Remove the cover strip clamp (1). To do so, loosen the two screws.
Keep the screws and the clamping plate (2) from falling down.
̈ Remove the rubber buffer at the strip deflection. To do so, loosen
the two screws.
̈ Remove the holding plate together with the strip deflection. To do
so, loosen the two screws.
̈ Pull out the entire cover strip.
̈ Remove the plastic unit from the housing of the strip deflection.
̈ Insert the new plastic unit into the housing of the strip deflection.
Clamping plate PAS41 PAS42 PAS43 PAS44
Set screw DIN 913 - 45H M3 x 10 M4 x 10 M5 x 16 M6 x 20
Wrench size [mm] 2.5 3 4 5
Tightening torque [Nm] 0.2 0.3 0.4 0.5
2
1