Filter
Top Products
66 Portal axes with ball screw drive
6 Diagnostics and troubleshooting PAS4•S
MNA1MLSDM00EN, V2.01, 07.2009
̈ Cut the new cover strip to the same length as the old cover strip
with the tin snips.
̈ Guide the new cover strip through the guide channel inside the car-
riage.
̈ Guide the new cover strip through the strip deflections.
̈ Place the holding plate for mounting the rubber buffer into position
at the strip deflection.
̈ Screw the strip deflection into place.
When doing so, align the strip deflection and the carriage.
̈ Place the cover strip over the entire length of the axis body.
Align the cover strip symmetrically so that the distance to the two
end blocks amounts to 1 ... 2 mm.
Verify that the cover strip has even contact with the magnetic strips.
̈ Fit the clamping plate (2) into place.
̈ Screw the cover strip clamp (1) into place with the tightening torque
specified in Table 6.1.
1... 2
2
1