Filter
Top Products
MNA1MLSDM00EN, V2.01, 07.2009
PAS4•S 6 Diagnostics and troubleshooting
Portal axes with ball screw drive 61
6.3 Replacing parts
Only replace the parts described. All other parts may only be replaced
by technicians trained by the manufacturer.
Carry out a complete installation for replacing the entire axis as per see
chapter 4 "Installation".
Adjust and check the linear axis as per chapter 5 "Commissioning" after
replacing parts.
6.3.1 Replacing a sensor
You can replace a sensor without changing the position of the sensor
holder.
Unless otherwise specified, the standard tightening
torques indicated on page 47 apply.
Prerequisites See chapter 7 "Accessories and spare parts" for suitable spare parts.
You need a set of Allen keys and a feeler gauge.
Procedure
̈ Loosen the M3 screw (2) at the slotted side of the sensor holder
until the sensor to be replaced can be pulled out from below.
̈ Mount the new sensor as described on page 50.
1
2
3