13
1.5) Connecting the PC 62C to the PC Backplane
Requirements: AT/286/386/486, ISA, EISA, Pentium, Pentium Pro Computer
Phillips Screw Driver (or one to match screw on the computer cabinet and
bracket)
16 bit bus slot
Procedure:
a) Switch off the computer and all attached devices
b) Unplug power cord from the computer and all attached devices.
++
Warning
Failure to disconnect all power cables can result in harzardous conditions, as
there may be dangerous voltage levels present in externally connected cables.
c) Remove the top cover from the PC. If you are not sure how to do this, consult the
manual supplied with the system unit.
d) Choose any 16 bit expansion slot and remove the screw from the metal bracket fixed
corresponding to the chosen slot.
e) Align the gold plated edge connector with the edge socket and the rear adaptor slot with
the board bracket. Firmly press the board down into the socket on the computer's system
board. Ensure that the board's edge connector is in the socket and has not slipped
sideways past the socket.
f) Replace the screw on the bracket and tighten the screw to the back panel.
g) Replace the computer's cover. Plug in all cables and switch the computer power on. The
PC 62C is now installed.
