Filter
Top Products
Parameters
Parameter Description
primary
The name of an existing virtual disk on the local
storage array that you want to use for the primary
virtual disk. Enclose the primary virtual disk name in
double quotation marks (“ ”).
secondary
The name of an existing virtual disk on the remote
storage array that you want to use for the
secondary virtual disk. Enclose the secondary
virtual disk name in double quotation marks (“ ”).
remoteStorageArrayName
The name of the remote storage array. Enclose the
remote storage array name in double quotation
marks (“ ”).
remoteStorageArrayWwn
The World Wide Identifier (WWID) of the remote
storage array. Enclose the WWID in double
quotation marks (“ ”).
remotePassword
The password for the remote storage array. Use
this parameter when the remote storage array is
password protected. Enclose the password in
double quotation marks (“ ”).
syncPriority
The priority that full synchronization has relative to
host I/O activity. Valid values are highest, high,
medium, low, or lowest.
autoResync
The settings for automatic resynchronization
between the primary virtual disks and the
secondary virtual disks of a remote replication pair.
This parameter has these values:
• enabled—Automatic resynchronization is
turned on. You do not need to do anything
further to resynchronize the primary virtual disk
and the secondary virtual disk.
• disabled—Automatic resynchronization is
turned off. To resynchronize the primary virtual
disk and the secondary virtual disk, you must
run the
start asyncReplicationGroup
command.
writeOrder
The write order for data transmission between the
primary virtual disk and the secondary virtual disk.
Valid values are preserved or notPreserved.
writeMode
How the primary virtual disk writes to the
secondary virtual disk. Valid values are
synchronous or asynchronous.
183