Dell 38XX Marine Radio User Manual


 
Parameters
Parameter Description
controller
The RAID controller module for which you want to
define properties. Valid RAID controller module
identifiers are 0 or 1, where 0 is the RAID controller
module in the top slot, and 1 is the RAID controller
module in the bottom slot. Enclose the identifier
for the RAID controller module in square brackets
([ ]). If you do not specify a RAID controller module,
the firmware for the controller returns a syntax
error.
availability
The mode for the RAID controller module, which
you can set to online, offline, or
serviceMode (service).
ethernetPort
The attributes (options) for the management
Ethernet ports. The entries to support this
parameter are listed in the Syntax Element
Statement Data table that follows. Many settings
are possible, including setting the IP address, the
gateway address, and the subnet mask address.
globalNVSRAMByte
A portion of the RAID controller module NVSRAM.
Specify the region to be modified using the starting
byte offset within the region and the byte value or
bit value of the new data to be stored into the
NVSRAM.
hostNVSRAMByte
The NVSRAM for the host-specific region. The
setting specifies the host index for the specific
host, the starting offset within the region, the
number of bytes, and the byte value or bit value of
the new data to be stored into the NVSRAM.
IPv4GatewayIP
The IP address of the node that provides the
interface to the network. The address format for
the IPv4 gateway is (0–255).(0–255).(0–255).
(0–255)
IPv6RouterAddress
The IP address of IPv6 router that connects two or
more logical subnets. The address format for the
IPv6 router is (0–FFFF):(0–FFFF):(0–FFFF):
(0–FFFF): (0–FFFF):(0–FFFF):(0–FFFF):
(0–FFFF).
iscsiHostPort
This parameter enables you to set options for the
iSCSI ports on the RAID controller module. Select
the specific iSCSI port and then select the options
for that port. The iSCSI port identifier can be 0, 1 or
2, 3. Refer to the information about your RAID
controller module for the location and identifier of
the ports.
300