Filter
Top Products
Parameter Description
file
The name of the file to which you want to save the
performance statistics. Enclose the file name in
double quotation marks (" ").
NOTE: This command does not automatically
append a file extension to the new file. You
must specify the file extension when you enter
the file name.
NOTE: If you have not reset the iSCSI baseline statistics since the RAID controller module
start‑of‑day, the time at the start‑of‑day is the default baseline time.
Save Storage Array Performance Statistics
Description
This command saves the performance statistics to a file. Before you use this command, issue the
set session performanceMonitorInterval and set session
performanceMonitorIterations commands to specify how often statistics are collected.
Syntax
save storageArray performanceStats file="filename"
Parameters
Parameter Description
file
Specifies name of the file to which to save the
performance statistics. You must put quotation
marks (" ") around the file name.
Save Storage Array SAS PHY Counts
Description
This command saves the storage array SAS physical layer (SAS PHY) counters to a file. To reset the SAS
PHY counters, run the Reset Storage Array SAS PHY Baseline command. See Reset Storage
Array SAS PHY Baseline.
Syntax
save storageArray SASPHYCounts file="filename"
280