Filter
Top Products
Parameters
Parameter Description
enclosure
Service tag of the RAID enclosure or the expansion
enclosure for which you are setting the enclosure
ID. You must put quotation marks (" ") around the
Service Tag.
id
Specifies the value for the RAID enclosure or
expansion enclosure ID. Valid values are 0 through
99. You do not need to put parentheses around
the enclosure ID value.
Set Event Alert Filtering
Description
The set event alert commands manage alert event notification by either disabling a specific critical event
alert from being sent, or by enabling notification about a specific critical event alert to be sent. To prevent
notification about a specific critical event alert from being sent, you block it. To enable notification about
a specific critical event alert to be sent, you unblock it.
The storage management software supports different priorities of events (such as Informational, Warning,
Critical). When you define your storage array, you can configure alerts and define how the event alerts
are managed. If you have configured the storage array to send alerts, then a notification is sent to a
designated recipient when a Critical event occurs. That notification can be one or all of the following
types:
• email
• syslog
• trap notifications
The set event alert CLI commands work on a single storage array. When you run the commands on a
storage array, only that storage array is affected by the commands. Other storage arrays that have not
had the CLI command run against them have the default behavior.
Blocking an event alert does not prevent the event from being posted to the system event log. All events
will continue to be posted to the event log.
Syntax
Syntax to Block an Event Alert
set blockEventAlert eventType
Syntax to Unblock an Event Alert
set unBlockEventAlert eventType
291