Dell 38XX Marine Radio User Manual


 
Parameter Description
values are 4 (4 KB), 8 (8 KB), 16 (16 KB), or 32 (32
KB).
cacheFlushStart
The percentage of unwritten data in the cache that
causes a cache flush. Use integer values from 0 to
100 to define the percentage. The default value is
80.
defaultHostType
The default host type of any unconfigured host
port to which the RAID controller modules are
connected. To generate a list of valid host types for
the storage array, run the show storageArray
hostTypeTable command. Host types are
identified by a name or a numerical index. Enclose
the host type name in double quotation marks (" ").
Do not enclose the host type numerical identifier
in double quotation marks.
failoverAlertDelay
The failover alert delay time in minutes. The valid
values for the delay time are 0 to 60 minutes. The
default value is 5.
mediaScanRate
The number of days over which the media scan
runs. Valid values are disabled, which turns off
the media scan, or 1 day to 30 days, where 1 day is
the fastest scan rate, and
30 days is the slowest
scan rate. A value other than disabled or 1 to 30
does not allow the media scan to function.
password
The password for the storage array. Enclose the
password in double quotation marks (" ").
userRole
Defines the user role for the password. The user
role can be either:
admin – Enables you to view and modify
storage array configurations
monitor – Enables you to view storage array
configurations and monitor storage array health
conditions, but not modify the configuration
The userRole parameter is optional. If you do
not use the userRole parameter, the storage array
uses any password that you define as the
administrator password.
userLabel
The name for the storage array. Enclose the
storage array name in double quotation marks (" ").
isnsRegistration
The means of listing the iSCSI target on the iSNS
server. Refer to the set storageArray
isnsRegistration command for information
about how to use this parameter.
320