Filter
Top Products
Parameter Description
replacementPhysicalDisk
Specifies the physical disks to assign to the virtual
disk that you want to create. Specify the enclosure
ID and slot ID for each physical disk that you assign
to the virtual disk. Enclosure ID values are 0 to 99.
Slot ID values are 0 to 31.
copyPhysicalDisk
This parameter copies the data from the physical
disk that you are replacing to the replacement
physical disk.
failPhysicalDisk
This parameter causes the physical disk that you
are replacing to be failed after the data has been
copied to the replacement physical disk. This
parameter can be used only when the
copyPhysicalDisk parameter is used.
Reset iSCSI IP Address
Description
This command resets the IP address for the remote storage array to re-establish connection with the
local storage array. You can use this command to notify the local storage array that the iSCSI IP address
of the remote storage array have changed and need to be updated.
When establishing an remote replication relationship with an iSCSI connection, both storage arrays store
a record of the IP address of the remote storage array of the remote replication configuration. If the IP
address of an iSCSI port changes, the remote storage array that is attempting to use that port encounters
a communication error.
The storage array with the changed IP address sends a message to each remote storage array associated
with the remote replication groups that are configured to replicate over an iSCSI connection. Storage
arrays that receive this message automatically update their remote-target IP address.
If the storage array with the changed IP address is unable to send its inter-RAID controller module
message to a remote storage array, the system sends you an alert of the connectivity issue. Use the
reset command to re-establish connection with the local storage array.
Syntax
reset (remoteStorageArrayName="storageArrayName" |
remoteStorageArrayWwid=<wwID>)
iscsiIpAddress
255