Filter
Top Products
Recurring Syntax Syntax Value
[physicalDiskType=physical disk-type]
[enclosureLossProtect=boolean]
WWID
string-literal
For hostPort identifiers this is a 16-digit hex
number without any colon delimiters.
nvsram-offset hexadecimal-literal
host-type string-literal | integer-literal
nvsram-byte-setting nvsram-value
(0x hexadecimal | integer-literal)
nvsram-bit-setting nvsram-mask, nvsram-value
(0x hexadecimal, 0x hexadecimal | integer-literal)
ipv4-address (0–255).(0–255).(0–255).(0–255)
ipv6-address (0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-list autoconfigure-vols-attr-value-pair
{autoconfigure-vols-attr-value-pair}
autoconfigure-vols-attr-value-pair physicalDiskType=physical disk-type|
raidLevel=raid-level |
diskGroupWidth=integer-literal |
diskGroupCount=integer-literal |
virtualDisksPerGroupCount=integerliteral|
hotSpareCount=integer-literal |
segmentSize=segment-size-spec
NOTE: The physicalDiskType parameter is
not required if only one type of physical disk is
in the storage array. If you use the
physicalDiskType parameter, you must
also use the hotSpareCount and
diskGroupWidth parameters. If you do not
use the physicalDiskType parameter, the
configuration defaults to SAS physical disks.
36