Filter
Top Products
Parameter Description
specify the length of time in minutes, hours, or
days.
NOTE: You must set the Recovery Point
Threshold to be twice as large as the
synchronization interval threshold.
warningThresholdPercent
Specify the percent value that determines when a
warning is triggered when the capacity of a
replication repository virtual disk reaches the
defined percentage. Define the threshold by
percentage (%) of the capacity remaining.
userLabel
The new name that you want to give to the remote
replication group. Use this parameter when you
want to rename the remote replication group.
Enclose the new remote replication group name in
double quotation marks (" ").
autoResync
The settings for automatic resynchronization
between the primary virtual disks and the
secondary virtual disks of a remote replicated pair
within a remote replication group. This parameter
has these values:
• enabled—Automatic resynchronization is
turned on. You do not need to do anything
further to resynchronize the primary virtual disk
and the secondary virtual disk.
• disabled—Automatic resynchronization is
turned off. To resynchronize the primary virtual
disk and the secondary virtual disk, you must
run the
resume remoteReplicationGroup
command.
virtualDisk
The name of the specific virtual disk that you want
to modify in the remote replication group. Enclose
the virtual disk name in double quotation marks ("
").
repositoryVirtualDisk
The name of the repository virtual disk for which
you want to increase capacity. An available
standard virtual disk is added to the repository
virtual disk to increase the capacity of the
repository virtual disk.
You have two options for defining the name of a
repository virtual disk:
• Use an existing repository virtual disk name.
• Create a new repository virtual disk when you
run this command.
The name of an existing repository virtual disk is
comprised of two parts:
• The term repos
307