Filter
Top Products
Parameter Description
label has special characters, enclose the HBA host
port label in double quotation marks (" ").
host
The name of the host to which the HBA host port
is connected. Enclose the host name in double
quotation marks (" ").
userLabel
The new name that you want to give to the HBA
host port. Enclose the new name of the HBA host
port in double quotation marks (" ").
NOTE: When you use this command, you can specify one or more of the optional parameters. You
do not, however, need to use all of the parameters.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set iSCSI Initiator
Description
This command sets the attributes for an iSCSI initiator.
Syntax
set iscsiInitiator (["iscsiID"] | <"wwID">)
(userLabel="newName" |
host="newHostName" |
chapSecret="newSecurityKey")
Parameters
Parameter Description
iscsiID
The name of the iSCSI initiator for which you want to
set attributes.
userLabel
The new name that you want to use for the iSCSI
initiator.
host
The name of the new host to which the HBA host
port is connected. Enclose the host name in double
quotation marks (" ").
chapSecret
The password that you want to use to authenticate a
peer connection.
NOTE: Challenge Handshake Authentication Protocol (CHAP) is a protocol that authenticates the
peer of a connection. CHAP is based upon the peers sharing a “secret.” A secret is a security key that
is similar to a password.
296