Filter
Top Products
Parameter Description
ID values are 0 to 31. You must put brackets ([ ])
around the enclosure ID value and slot ID value.
Start Remote Replication Synchronization
Description
This command starts Remote Replication synchronization.
Syntax
start asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
synchronize [deleteRecoveryPointIfNecessary]
Parameter
Parameter Description
asyncRemoteReplicationGroup The name of the remote replication group for
which you want to start synchronization. Enclose
the remote replication group name in double
quotation marks (" ") inside square brackets ([ ]").
deleteRecoveryPointIfNecessary The parameter to delete the recovery point if the
recoverable synchronization data has exceeded
time threshold for recovery. Recovery point age is
measured from the time the data was frozen on
the primary storage array.
Start Remote Replication (Legacy) Synchronization
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command starts Remote Replication (legacy) synchronization.
Syntax
start remoteReplication primary
[”virtualDiskName”] synchronize
Parameters
Parameter Description
primary
The name of the primary virtual disk for which you
want to start synchronization. Enclose the primary
virtual disk name in double quotation marks (“ ”)
inside square brackets ([ ]).
386