Filter
Top Products
8. CUSTOMIZING THE EQUIPMENT
8-8
8.3 USER PROG Control
The [USER PROG] control provides for instant setup of the equipment according
to fishing ground or target fish. Ten programs may be set up, and vertical and
horizontal display settings may be programmed together or individually. (The
default settings programs them together.) For how to program them individually
see your dealer.
8.3.1 Selecting a user program
Rotate the [USER PROG] control clockwise or counterclockwise to select
program desired. Selected program no. appears at the top right-hand corner of
the screen to the right of “P”. If the equipment is turned off with a user program
active, it starts up with those settings at the next power on.
8.3.2 Programming the USER PROG control
1. Set the equipment as desired. You can set up all items on the H-SCAN
SETTING and V-SCAN SETTING menus as desired.
2. Press the [MENU] key to open the menu.
3. Select OTHERS and press the [MENU] key.
4. Select PRESET, MEMORY CARD and press the [MENU] key. One of the
following menus appears depending on the setting of “SELECT USER
PROG” on the MISC menu of the SYSTEM menu. (For SYSTEM menu,
contact your dealer or refer to installation manual.)
PRESET, MEMORY CARD
OTHERS
MENU QUIT
QUIT
QUIT
ASSIGN USER PROG...
CLEAR F-KEY SETTING...
H/S-SCAN RANGE
V-SCAN RANGE
PICTURE SHOT : EXECUTE
PICTURE RECALL : EXECUTE
MEMORY CARD...
PRESET, MEMORY CARD
OTHERS
MENU QUIT
QUIT
QUIT
ASSIGN USER PROG-H...
ASSIGN USER PROG-V...
CLEAR F-KEY SETTING
H/S-SCAN RANGE
V-SCAN RANGE
PICTURE SHOT : EXECUTE
PICTURE RECALL : EXECUTE
MEMORY CARD...
User program set jointly for
horizontal and vertical displays
User program set individually for
horizontal and vertical displays
PRESET, MEMORY CARD menu
5. Select ASSIGN USER PROG, ASSIGN USER PROG-H/S or ASSIGN USER
PROG-V as appropriate and press the [MENU] key.