Filter
Top Products
SAFETY INSTRUCTIONS
iii
CAUTION
Observe the following precautions when
using industrial use lubricant.
Precautions
Q
Keep lubricant away from eyes. Wear protective
goggles when working with the lubricant.
The lubricant can cause inflammation of the eyes.
Q
Do not touch the lubricant. Wear protective gloves
when working with the lubricant. The lubricant can
cause inflammation of the skin.
Q
Do not ingest the lubricant. Diarrhea and vomiting
may result.
Q
Keep the lubricant out of reach of children.
Emergency procedures
Q
If the lubricant enters eyes, flush with clean water
about 15 minutes. Consult a physician.
Q
If the lubricant contacts skin, flush area with clean
water.
Q
If the lubricant is ingested, see a physician
immediately.
Disposal of lubricant and its container
Dispose of the lubricant and its container in accord-
ance with local regulations. If you are unclear about
the disposal procedure, contact a FURUNO agent or
dealer for advice.
WARNING LABELS
Warning labels are attached to the units of the system. Do not remove the labels.
If a label is missing or damaged, contact a FURUNO agent or dealer about replacement.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Name: Warning Label (1)
Type: 86-003-1011-1
Code No.: 100-236-231
DANGER
Keep fingers away
from gears.
Shaft may cause injury.
Keep away froom
moving shaft.
Name: Warning Label
Type: 10-071-5313
Code No.: 100-291-160
DANGER
goes off and then remove cover.
Turn off power before servicing.
No user-serviceable parts inside.
And wait until charge lamp (green)
Do not remove cover.
Electrical shock hazard.
DANGER
Name: Warning Label
Type: 10-079-6144
Code No.: 100-310-880
Name: Warning Label (2)
Type: 03-129-1001-1
Code No.: 100-236-741
CAUTION
Maximum speed while the transducer is
projected and being raised or lowered
is as below, to prevent damage to the
transducer.
Replace anticorrosion zinc plate yearly.
Corrosion between the main shaft and
transducer may result if not replaced, allowing
water leakage and/or loss of transducer.
Projected Raising/
Lowering
800 mm stroke Max. 18 kt Max. 15 kt
1100 mm stroke Max. 18 kt Max. 15 kt
WARNING
To avoid electrical shock,
do not remove cover.
No user-serviceable parts
inside.