Filter
Top Products
4.18 WATLOW Series 988 User’s Manual
Setup Menus, Chapter 4
Setup-Output
MODE
*Hysteresis 4
*Alarm 4 Side
*Alarm 4
*Output 4
*Silencing 3
*Latching 3
*Hysteresis 3
*Alarm 3 Side
*Alarm 3
*Output 3
*Silencing 2
*Latching 2
*Alarm 2 Side
*Alarm 2
*Set Point 2 Control
*Hysteresis 2
*Output 2
*Process 2
Setup Prompt
Output 1
*Process 1
*Hysteresis 1
Enter your settings,
from the controller's
upper display.
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
Output 2 (p. 4.21)
Output 1 (p. 4.19)
Output 4 (p. 4.28)
Output 3 (p. 4.25)
*Retransmit Calibration Offset
*Retransmit High Limit
*Retransmit Low Limit
*Process 3
*Analog Output
*Silencing 4
*Latching 4
MODE
MODE
MODE
MODE
MODE
MODE
MODE
Output 3 retransmit
(p. 4.31)
[A`rH]
[A`rL]
[OtPt]
[`set]
[`Ot1]
[Prc1]
[HyS1}
[`Ot2]
[Prc2]
[Hys2]x
[Sp2c]
[`Al2]
[A25d]
[LAt2]
[SIL2]
[`Ot3]
[`Al3]
[A3sd]
[Hys3]
[Lat3]
[SIL3]
[`Ot4]
[`AL4]
[A4Sd}
[HyS4]
[LAt4]
[SIL4}
[Aout]
[Prc3}
[ACAL]
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.
Input
Menu
p. 4.2
Output
Menu
p. 4.18
Global
Menu
p. 4.34
Communications
Menu
p. 4.44
[Inpt]
[`Set]
[`Set] [`Set]
[`Set]
[OtPt] [gLbL] [COm]
❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
Menus.
❷ Press the Up-arrow key > to select
one of the Setup Menus.
[`Ot1] [`Ot1]
[``Ht] [``CL]
…
…
…
[```1]
[```2]
[```3] [`999]
[Hys2][Hys2]
[Hys2] [Hys2]
Reaching the Output Menu
Figure 4.18 -
Navigating the
Output Menu.
*Prompts may not appear,
depending on controller
configuration.
p. 4.2 p. 4.18 p. 4.34 p. 4.44
(p.
4.19
)
(p.
4.21
)
(p. 4.25
)
(
p. 4.31
)
(
p.
4.28
)