Filter
Top Products
Chapter 19 Log Screens
NWA-3500/NWA-3550 User’s Guide
233
19.6.2 Log Commands
Go to the command interpreter interface (refer to Appendix F on page 379 for a discussion
on how to access and use the commands).
19.6.3 Configuring What You Want the NWA to Log
Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the NWA is to record.
0 A gateway may discard internet datagrams if it does not have the buffer
space needed to queue the datagrams for output to the next network on
the route to the destination network.
5 Redirect
0 Redirect datagrams for the Network
1 Redirect datagrams for the Host
2 Redirect datagrams for the Type of Service and Network
3 Redirect datagrams for the Type of Service and Host
8 Echo
0 Echo message
11 Time Exceeded
0 Time to live exceeded in transit
1 Fragment reassembly time exceeded
12 Parameter Problem
0 Pointer indicates the error
13 Timestamp
0 Timestamp request message
14 Timestamp Reply
0 Timestamp reply message
15 Information Request
0 Information request message
16 Information Reply
0 Information reply message
Table 77 Sys log
LOG MESSAGE DESCRIPTION
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>"
This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix’s other charts.
Table 76 ICMP Notes (continued)
TYPE CODE DESCRIPTION