Chapter 20 VLAN
NWA-3500/NWA-3550 User’s Guide
241
On an Ethernet switch, create a VLAN that has the same management VLAN ID as the NWA.
The following figure has the NWA connected to port 2 of the switch and your computer
connected to port 1. The management VLAN ID is ten.
Figure 145 Management VLAN Configuration Example
Perform the following steps in the switch web configurator:
1 Click VLAN under Advanced Application.
2 Click Static VLAN.
3 Select the ACTIVE check box.
4 Type a Name for the VLAN ID.
5 Type a VLAN Group ID. This should be the same as the management VLAN ID on
the NWA.
6 Enable Transmitted Packets (Tx) Tagging on the port which you want to
connect to the NWA. Disable Tx Tagging on the port you are using to connect to
your computer.
7 Under Control, select Fixed to set the port as a member of the VLAN.
Figure 146 VLAN-Aware Switch - Static VLAN