Filter
Top Products
75
Lorex Auto Port Forwarding Wizard
Configuring a DMZ host connection
• Connect to "Router 1" on your network (referred
to as "Possible 1st Router" in the Auto Port
Forwarding Wizard). Obtain the IP address of
Router 1. Usually this can be found in the
"Status" section of your router menu. The IP
should begin with "192.168...."This IP address is
your DMZ IP.
• Enter the IP address obtained from Router 1 into
the DMZ section of Router 2.
• Once you have configured Router 2 with a DMZ
connection, run the Auto Port Forwarding
Wizard to begin auto port forwarding to Router 1.
• Consult your router’s owner’s manual for details
on configuring DMZ settings.
Example
DMZ stands for Demilitarized Zone. Enabling a DMZ
IP on your router enables one of the routers to pass
information onto the second router.
DMZ IP address
assigned by a
secondary router
Figure 27.11 Entering DMZ information.
Locating your Router IP - The Status Page
Router IP assigned by
the main router. Enter
this IP into the DMZ
section of the primary
router.
The IP information is
normally under a
header called "WAN" or
"Internet Port". Each
router has different
terminology.
The "Status Page" of a router normally includes the router’s
vital information such as the IP address.
Figure 27.12 Router status page.
Locating your Router IP - The Status Page
EXAMPLE