Filter
Top Products
28
5. ENT – This key allows you to save data, accept values or execute
menu commands. It is also used to create event marker icons.
6. EXIT – The Exit key lets you return to the previous screen, clear
data or close a menu.
7. WPT – The Waypoint key is used to save and recall waypoints,
search for waypoints and access the waypoint list. It's also involved in
some navigation functions.
8. ZOUT – This key lets you zoom the screen out. On the Sonar Page,
this key returns you to a full sonar chart display, showing the entire
water column from surface to bottom. On the Plotter Page, this lets you
see a larger geographic area on the display. Less detail is seen as you
zoom out.
9. ZIN – This key lets you zoom the screen in. On the Sonar Page, this
key enlarges fish signals and bottom detail. On the Plotter Page, zoom-
ing in lets you see greater detail in a smaller geographic area on the
display.
Main Menu
Access the Main Menu by pressing
MENU|MENU. Select a menu item by
using ↑ or ↓ to highlight the command and pressing
ENT. To clear the
Main Menu screen and return to the Page display, press
EXIT.
Main Menu Commands
• Screen:(CONTRAST, BRIGHTNESS and DISPLAY MODE):
change the appearance of the display screen. Use
these commands to adjust how the screen looks
under various lighting conditions.
• Sounds: controls sound levels for keystrokes
and alarms.
• Alarms: turns alarms on or off and changes
alarm thresholds.
NOTE:
Route Planning, My Trails, GPS Setup and
Trip Calculator will be addressed in the GPS
section.
• Set Keel Offset: calibrates the unit to show depth under the keel or
actual depth from the surface.
• Sonar Simulator: turns the unit's simulator feature on and off.
• System Setup: provides access to general configuration options, like
Units of Measure, Reset Options, Pop-up Help, Set Language, etc.