Filter
Top Products
44
To turn off overlay data:
1. Press MENU|↓ to OVERLAY DATA|ENT.
2. Press ↓ or ↑ to select Data Type, then press
ENT until the check mark
to the left of the selected data type disappears.
3. To return to the previous page, press
EXIT|EXIT.
To change overlay data font size:
1. Press MENU|↓ to OVERLAY DATA|ENT.
2. Press ↑ or ↓ to select Data Type. The
DATA SIZE
(displayed in the bottom of the Overlay Data
Shown window) can be changed using ← or →.
When a desired size is achieved, press
EXIT.
3. To return to the previous page, press
EXIT.
Ping Speed & HyperScroll™
Ping Speed controls the rate at which the transmitter and transducer
broadcast sonar sound waves — pings — into the water. The unit has a
default ping speed of 50 percent, which automatically provides enough
return echoes to scroll the chart at normal boating speeds.
However, when you are running at high speeds you may want to use
the HyperScroll™ feature. When you change the Ping Speed to any set-
ting greater than 50 percent, the unit automatically enters HyperScroll
mode.
At left, Sonar Menu with Ping Speed command selected.
Ping Speed Control Bar, right, at default setting.
To change Ping Speed:
1. From the Sonar Page, press MENU|↓ to PING SPEED|ENT.
2. The Ping Speed Control Bar appears. Press ↑ to increase ping speed;
press ↓ to decrease ping speed. Press
EXIT.
Overlay
Data