Filter
Top Products
65
3. If the list is short, you can jump directly to the FIND IN LIST box by
pressing
ENT. Use ↑ or ↓ to select the waypoint name, press ENT and
the waypoint information screen appears with the
GO TO command se-
lected.
Waypoint information screen on waypoint 004. Screen shows name, lati-
tude/longitude, distance to waypoint and its compass bearing. Figure at
left shows Go To command; right figure shows Find On Plotter command.
4. You can use ← or → to select various options on
the waypoint information screen. If you wanted to
navigate there, just press
ENT, since the GO TO
command is highlighted. If you want to see it on
the plotter, press → to
FIND ON PLOTTER|ENT.
5. The M52's plotter appears, with the cross-hair
cursor highlighting the waypoint's symbol. A
pop-up name box identifies the waypoint, as well
as its distance and bearing. A data box at the
bottom of the screen continues to display the
location's latitude and longitude.
7. To clear the search and return to the last page
displayed, press
EXIT|EXIT.
Navigate To a Waypoint
You can select any waypoint visible on the Plotter Page with the cur-
sor, and then use the Navigate to Cursor command. Or, you could avoid
scrolling the plotter to pick your waypoint if you use the Find Waypoint
commands:
1. Press
WPT. To look up the nearest waypoint, just press ENT; or, to
look by name (and scroll through the entire waypoint list), press ↓ to
FIND BY NAME|ENT. For this example, look by name.
Plotter screen
showing Find
Waypoint.