Filter
Top Products
45
To adjust Sensitivity:
1. From the Sonar Page, press MENU|ENT.
2. The Sensitivity Control Bar appears. Press ↓ to decrease sensitivity;
press ↑ to increase sensitivity. When it's set at the desired level, press
EXIT. (When you reach the maximum or minimum limit, a tone sounds.)
To turn off HyperScroll:
1. From the Sonar Page, press MENU|↓ to PING SPEED|ENT.
2. The Ping Speed Control Bar appears. Press ↓ to decrease ping speed
to 50 percent. When it's set at the desired level, press
EXIT.
When you enable HyperScroll, the width of the FasTrack bar graph
display doubles in width at the right side of the screen, giving you a
better view of Fastrack's instantaneous sonar returns.
Reset Options
This command is used to reset all features, options
and settings to their original factory defaults. This
is useful when you have changed several settings
and want to return the unit to basic automatic op-
eration.
1. Press
MENU|MENU|↓ to SYSTEM SETUP|↓ to RESET
OPTIONS|ENT.
2. Press ↑ or ↓ to
YES|ENT.
3. All features and options are returned to the factory default settings.
Sensitivity & Auto Sensitivity
The sensitivity controls the ability of the unit to pick up echoes. A low
sensitivity level (from zero to 50 percent) excludes much of the bottom
information, fish signals, and other target information. High sensitivity
levels let you see this detail, but it can also clutter the screen with many
undesired signals. Typically, the best sensitivity level shows a good solid
bottom signal with Colorline and some surface clutter.
Automatic Sensitivity
This unit has two sensitivity modes: Automatic and Manual. In auto-
matic you can adjust sensitivity up to 100 percent but the unit will
limit your minimum setting.
In manual mode, you have complete control over sensitivity, with the
ability to set it anywhere from zero to 100 percent.