Filter
Top Products
82
4. When your adjustments are finished, return to the last page dis-
played by repeatedly pressing
EXIT.
IMPORTANT ALARM NOTES:
Anchor Alarm — The anchor alarm may be triggered even when
you are sitting still. Typically, this happens when using small (less
than 0.05 mile) anchor alarm ranges.
Arrival Alarm — If you set the arrival alarm's distance to a small
number (less than 0.05 mile), the unit may not show navigation
data to the next waypoint after you arrive at the first one because
you may not be able to come close enough to the first waypoint to
trip the arrival alarm.
Auto Satellite Search
When your GPS receiver is turned on for the first time, it will not know
your position. The unit begins searching for the satellites using the
data it acquired the last time it was turned on, probably at the factory.
Since it's almost certain that you are not at the factory, it is probably
looking for the wrong satellites.
If it doesn't find the satellites it's looking for after approximately one
minute, it switches to Auto Search, looking for any satellite in the sky.
Once the unit locks onto the satellites, it should take less than a minute to
find your position the next time it's turned on, provided you have not
moved more than approximately 100 miles from the last location it was
used.
GPS Auto Search on the Satellite Status Menu.
You can force the unit to switch to auto search mode.
1. Press
PAGES and switch to the Satellite Status screen.
2. Press
MENU|↓ to GPS AUTO SEARCH|ENT|← to YES|ENT.