104 GL-1010 Administrator’s Guide
RECOVERY UPDATE
The e-STUDIO GL-1010 Recovery CD-ROM is used to upgrade
or restore the operating system on the GL-1010 controller. There
are two ways to update the operating system:
n Boot the GL-1010 from the e-STUDIO GL-1010 Recovery
CD-ROM.
n Perform a OS Update from the copier control panel. This is
the recommended method of updating the OS software. The
controller performs a backup operation and saves the network
settings, which are then restored following the update.
This section provides procedures for performing each method of
Operating System update.
Update from Bootable CD-ROM
1 Power up the e-STUDIO28/35/45 system.
2 Immediately insert the e-STUDIO GL-1010 Recovery CD-
ROM into the drive. The flashing light on the CD-ROM drive
indicates the controller is trying to boot off of the CD. If this
light does not flash, leave the CD in the drive and reboot the
controller.
3 Check the LCD Touch Screen on the copier. It displays the
following message as the controller boots off of the
CD-ROM:
Starting controller. Please wait.
NOTE:
If the Scan kit option is
installed, be sure to back up
the templates and
addressbook before
recovering or updating
controller software. They
are deleted during recover/
update process.