26 GL-1010 Administrator’s Guide
Configuring Token Ring Settings
1 From the Network Setting menu, press TOKEN RING to display
the
Token Ring Setting screen:
2 Set the Token Ring speed: 4MB/S or 16MB/S. Alternately,
select
AUTO to automatically sense and set the correct speed.
3 Press OK to save the changes for the duration of the session.
The
Apply Changes Check screen is displayed any time
controller settings change:
4 If you are finished changing controller settings, press YES.
Otherwise, press
NO to continue your session. Once the
controller reboots, a configuration page prints out. Verify that
the settings were changed successfully.
NOTE:
The Token Ring Settings
screen appears only if a
Token Ring NIC is
installed in the GL-1010.
NOTE:
Check the configuration
page that automatically
prints upon start up to
confirm that the changes
were applied.
