GL-1010 Administrator’s Guide 161
4 Power on the Toshiba e-STUDIO28/35/45. Inspect the start-
up page that prints out to make sure that the option reads
“installed.”
Installing the Twain Driver
If you install the Twain driver and set up the appropriate Twain
Scan Agent, scanned images may be acquired using a Twain
compliant application.
1 Insert the e-STUDIO GL-1010 Scanner Client CD-ROM into
the drive. If autoplay is enabled, the InstallShield setup
wizard launches automatically. If it doesn’t start, choose Run
from the Start menu and then enter the following command:
D:\setup.exe,
replacing “D” with the letter mapped to your CD-ROM drive,
if different.
2 The setup wizard displays the End User Licence Agreement.
Please read the terms of license carefully. If you agree with
the terms, click
Yes to continue installation. Otherwise, click
No to terminate the installation process.
3 The necessary system files are copied to your workstation.
When complete, click
Finish.
Defining Scanner Agents
Agents contain the transfer mode properties for completed scans.
Agents can be set up to perform the following functions:
n Email a scanned image
n Save a scan to the GL-1010 controller or a network file server
n Save the scan as a twain-compliant image
n Fax the scanned image by Email
As an Administrator, you will configure agent settings to enable
users to scan and transfer the scanned document to the
appropriate destination. Users will set up the specific details for
how to handle each different Agent.
The dongle and iButton hardware must be installed on the
controller for the Agents to display and work properly. If a
warning message displays "Cannot locate a scan agent", check if
the dongle and iButton are installed properly.
