Filter
Top Products
Protect PV.630 Operating Instructions
8000047961 BAL 53 of 72
Figure 18 Main menu
If the configuration does not start, you must wait for 10 seconds
and then repeat the procedure. Make sure that no data is received
via the X2/X5 interfaces during this time.
Press the following key in the main menu:
<CR> to save the set values, exit the configuration and activate
the MultiCom interface.
<ESC> to cancel the configuration.
<2> to access the X5 data transmission configuration.
<4> to access the X5 data protocol configuration.
The possible keyboard actions are shown in the menu in “< >”.
The following special keys can be used in the menus:
<CR>: Carriage return () or ENTER key
<ESC>: Escape key
<TAB>: Tabulator () key
<BS>: Backspace () or Rubout key
< >: Space bar