Filter
Top Products
Protect PV.630 Operating Instructions
54 of 72 8000047961 BAL
7.1.4.2 Configuring the Modbus Protocol
To access the X5 data protocol configuration, you must press <4>
in the main menu:
Figure 19 Data protocol configuration
Press one of the following keys in the “X5 Data Protocol” menu:
<TAB> to configure the Modbus protocol
<CR> to accept the set values. The configuration is finished and
the main menu is opened again.
<ESC> to cancel the configuration. This opens the main menu.
Figure 20 Modbus protocol configuration
Press one of the following keys in the “X5 Data Protocol – Mod-
bus/JBusV2” menu:
<!> to load the factory setting.
<1> to configure the Modbus slave address.
<2> to configure the delay time between a request from the
master and the response from the slave.
<CR> to accept the set values. The configuration is finished
and the main menu is opened again.
<ESC> to cancel the configuration. This opens the main menu.