Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Compact Modular Cabinets
555-230-128
Issue 3
May 1998
Install and Cable the Cabinets
Page 1-2Unpack and Inspect
1
2. Equipment comcodes are listed in Ta b le 1 -1 .
3. Before mounting the cabinets, remove the cabinet doors by opening them
and lifting them straight up and off of the hinge pins.
Figure 1-1. Equipment Packed with the CMC Cabinet
Figure Notes
1. Left panel (also acts as a wall-mount template
and as a floor mount pedestal)
2. CMC cabinet
3. Right panel
4. U.S. Robotics external modem (not shipped
with all systems)
5. #12 x 1-inch shoulder screws
6. Processor interface cable (not shipped with all
cabinets)
7. AC power pord (NEMA 5-15P or
IEC 320)
8. Vertical TDM/LAN bus cable (not
shipped with all systems)
9. Horizontal TDM/LAN bus cable
(not shipped with all systems)
10. 14-inch (35.5 cm) 6 AWG (#40) (16
mm
2
) ground wire
11. Single-point ground block
qrdmpart KLC 011598
6
7
4
8
9
10
11
5
3
2
1