3 - 3
3 SETTING PARAMETERS
No. 99MBC034B
(3) To complete the setting operation press the P.SET key
while holding down the Fn key. If the EV-16Z is used, push
in the spindle to pass through the origin.
In order to continue the setup operation for other parameters
simply press the Fn key.
TIP Relationship between the parameter setup values and
available axes
An EV Counter has six internal counters (CEL 1 - 6).
Data of gages connected to the gage input connectors,
INPUT A - F, will be displayed/output as the data of CEL
1 - 6, respectively.
Available axes are designated by determining the rela-
tionship between INPUT A - F and CEL 1 - 6. The follow-
ing table lists the possible combinations.
Setup value
CEL1 CEL2 CEL3 CEL4 CEL5 CEL6
1
INPUT A INPUT A INPUT A INPUT A INPUT A INPUT A
2
*1
INPUT A INPUT B INPUT A INPUT B INPUT A INPUT B
3
INPUT A INPUT B INPUT C INPUT A INPUT B INPUT C
4
INPUT A INPUT B INPUT C INPUT D INPUT A INPUT B
5
INPUT A INPUT B INPUT C INPUT D INPUT E INPUT A
6
*2
INPUT A INPUT B INPUT C INPUT D INPUT E INPUT F
*1
: If the setup value is "2", internal counters CEL1, 3, and 5 will
display/output the data of INPUT A. Internal counters CEL2, 4,
and 6 will display/output the data of INPUT B. By setting a differ-
ent tolerance value for each of CEL1, 3, and 5, three different
types of tolerance judgments can be made from the data of IN-
PUT A.
*
2
: The factory-set default is "6".
3.1.4 Parameter mode OFF
(1) Press the P.SET key while holding down the Fn key to set
the parameter mode to OFF. If the EV-16Z is used, push in
the spindle to pass through the origin. The parameter setup
is modified and the Display Unit returns to the count value
display.
NOTE • If the P.SET key is pressed during the setup operation
and while the Fn key is being held down, the setup
operation is interrupted and the count value display is
restored. (If the EV-16Z is used, push in the spindle to
pass through the origin.) If this occurs, the modifica-
tions made up to the interruption are reflected in ac-
tual operation.
• During parameter setup operation, the parameter in-
put switch, RS-232C output, and external signal input
are all disabled.
