7 - 3
No. 99MBC034B
7 I/O FUNCTION
No. Name I/O
Functional description
19 CEL5_-NG OUT Tolerance judgment result of CEL5 -NG
20 CEL5_GO OUT Tolerance judgment result of CEL5 GO
21 CEL5_+NG OUT Tolerance judgment result of CEL5 +NG
22 CEL5_NOM OUT Error signal of CEL5
*
1
23 CEL6_-NG OUT Tolerance judgment result of CEL6 -NG
24 CEL6_GO OUT Tolerance judgment result of CEL6 GO
25 CEL6_+NG OUT Tolerance judgment result of CEL6 +NG
26 CEL6_NOM OUT Error signal of CEL6
*
1
27 EXTENDED OUT L: Execution of an RS-232C command, which
is activated by a HOLD input, is being
performed.
H: Execution of an RS-232C command, which
was activated by a HOLD input, has been com-
pleted.
Purpose: Monitoring the RS data communica-
tion condition at the I/O port.
28 READY OUT "L" if the output data has been accepted.
29 START OUT "L" only when CEL1 data has been output.
30 NORMAL OUT "H" at an anomaly.
(Result of ORing NOMs of all CELs.)
31 P.SET IN Presets the specified CELs.
32 OUTCEL IN Sets the output CEL/calculation method
33 SET1 IN specified by SET1 through SET3 if the ON
34 SET2 IN signal of OUTCEL was input.
35 SET3 IN
36 HOLD IN The display value is held during input. The
error is cleared at the rise of this signal.
Only EV-16Z re-detects the origin if the
parameter No.42 is set to 1.
*1: "L" if counting is permitted.
*: Outputs of No.3 through No.26 can be logically inverted by the I/O
output logic parameter.
**: Inputs of No.31 through No.36 are valid at "L".
4) Designating the CEL for "P.SET"
For the detailed procedure, refer to section 7.7.4 External
presetting.
SET3 SET2 SET1
CEL specified
000All CELs
001CEL1
010CEL2
011CEL3
100CEL4
101CEL5
110CEL6
111Specification prohibited.
0="H" 1="L"
