7 - 11
No. 99MBC034B
7 I/O FUNCTION
Displays the sum after displaying CL07_1.
Displays the mean after displaying CL08_2.
Displays the maximum value after displaying CL09_3.
Displays the minimum value after displaying CL10_4.
Displays the MAX - MIN after displaying CL11_5.
* All the keys except the DISP key will be disabled in
the calculation mode.
• Difference between CH06=F and CH06_F.
If the setups of SET1 to SET3 are not '000' (some
calculation item has been specified), and if CH06 is
specified with the DISP key, the measured value will
be displayed after 'CH06_F' is displayed. This means
that "_" indicates that tolerance judgment output is not
performed for the CH06 measurement value (i.e. the
tolerance judgment output is performed for the calcu-
lation result).
In other cases, where SET=000, a tolerance judg-
ment will be output to the measured value of CH06
and the measured value will be displayed after
'CH06=F' is displayed.
7.5.3 BCD output
1) Function
• Outputs the calculation results specified by SET1
through SET3 as the BCD data.
• Outputs the data of all CELs as a time-division BCD, if
the setups of SET1 to SET3 are "000".
2) Parameter setup
•
I/O function selection parameter: Set to the calculation mode.
• I/O-type selection parameter: Set to BCD output.
• Calculation axis designation parameter:
Select one between 0 and 3.
7.5.4 Segment output
1) Function
• Outputs the calculation result specified by the input of
SET1 to SET3 as segment data.
• If SET3 through SET1 are all "000", the data of all CELs
will be output in a time-divided format.
2) Parameter setups
•
I/O function selection parameter: Set to the calculation mode.
• I/O type selection parameter: Set to segment output.
• Calculation axis designation parameter: Select one be-
tween 0 and 3.
