5 - 5
5 RS-232C COMMUNICATION FUNCTION
No. 99MBC034B
5.2.5 RS-232C command and RS-232C response output
LF
Command
Response
output
Max. 10ms
(
If the GA command is issued
)
Min. 10ms
LF
LF
NOTE During key operation RS-232C output will be sus-
pended, and it will be resumed after the key operation
has been completed.
5.2.6 HOLD input and RS-232C response output
LF
HOLD
EXTEND
Max. 70ms
Min. 10ms
Min. 10ms
Data latch for
10 µs [10 ms]*
* A value in brackets denotes a numeric value
at a MAX, MIN, or TIR measurement.
Response
output
NOTE • During key operation RS-232C output will be sus-
pended, and it will be resumed after the key operation
has been completed.
• If the RS LINK connection has been established, the
EXTEND command is valid for the counter placed at
the end of the chain.
• EXTEND output will be in effect only if the I/O mode
parameter is set to "Interval mode".
• While the HOLD signal is being input, the D-EV UNIT
LED flashes.
• In order to trigger data output from the RS-232C con-
nector with the HOLD input signal set the HOLD se-
lection parameter to "RS-232C". (In this state an RS-
232C command cannot be input.)
• If the High-speed mode is specified, set the output cell
to "All CELs".
