8 - 5
8 SPECIFICATIONS
NOTE If an error occurs during a parameter,
preset value, or tolerance value setting
operation, the error code will be dis-
played only after the counting state has
been restored. However, the error
code will be output immediately.
In the high-speed mode, an error code
will be output only if the CH that
caused the error is specified for output.
If the EV-16Z is used, perform origin
re-input after removing the error cause
to cancel the error.
*1: This operation is performed when the I/O output logic parameter has the initial
setting.
*2: The error code will be output and displayed when the CH that caused the error is
specified for output.
*3: Displayed if a tolerance setup error occurs due to a key operation.
*4: The error output format will be CH
**
,Error$$CRLF.
*5: Output if a tolerance setup error occurs due to an RS command.
*6: A parameter LED (1 to 6) corresponding to the CH that caused the error will be
turned on.
*7: Any CH, to which the gage is not properly connected according to the available
axis designation parameter, will cause an error.
*8: The count data in the EV counter is normal. The display will be restored to the
normal state when the count data falls within the displayable range.
*9: Irrespective of the I/O logic, "H" will be output if an error occurs.
*
10
:Automatically canceled if the gage type parameter has been set to 1 or 2 with the
EV-16D.
