7 - 17
No. 99MBC034B
7 I/O FUNCTION
7.7.5 Designating CELs to be output/Specifying the calcula-
tion method
Assign a CEL that has been specified by SET1 through SET3 as
the data output CEL.
SET 1, 2, 3
OUTCEL
DATA
Min. 10ms Min. 10ms
Max. 40ms
Min. 15ms
Inputs of SET1 through SET3 for segment output
Usually, these function as range specification data (or as
output CEL designation data if an OUTCEL signal is input).
Refer to section 7.4.4 Segment output.
Operation varies depending on the setups of the I/O function
selection parameter.
•
NORMAL or high-speed mode: Output CEL designation.
• Calculation mode: Specification of calculation method.
7.7.6 Peak clear
Clears the peak values.
(Max.= Min. = current value, TIR = 0)
Min. 10ms
Min. 10ms
Max. 40ms
Min. 15ms
SET 1, 2, 3
HOLD
P. SET
DATA
NOTE • Peak clear will be effective if the peak mode setup is
other than "Current value". If "Current value" is speci-
fied, presetting is perfromed.
• With the EV-16D, the data update period depends on
the gage connected. In addition, the same data may
be output repeatedly over multiple cycles.
