4 - 2
No. 99MBC034B
4.2 Switching the Display/Output CH (with D-EV)
Use the DISP key to switch the display/output CH (channel).
This section explains the procedure, using the top EV Counter
connected via the RS LINK function as an example.
(1) When the counter enters the counting mode after the power
is turned on, the count value of CH01 (CEL1) is displayed
on the D-EV, and the corresponding GAGE No. LED is
turned on.
[GAGE No. LED Indicator]
GAGE
TIP • CH numbers (01 - 99) will be automatically assigned
to the EV counters sequentially from the top as they
are connected via the RS LINK function. If only one
counter is connected, it is assigned CH numbers 01
through 06, which corresponds to CEL1 through
CEL6. For more information refer to chapter 5, "RS
LINK FUNCTION".
• GAGE No. LEDs show the currently displayed CEL
number with the corresponding on/off pattern.
CEL1
GAGE
CEL2
GAGE
CEL3
GAGE
CEL4
GAGE
CEL5
GAGE
CEL6
GAGE
(2) If the DISP key is pressed, the display/output CH is
switched to the next display/output CH, displaying the
count value of CH02 (CEL2). While the DISP key is held
down, the CH number (CH02) and gage input connector
number (= b) is displayed on the D-EV.
[GAGE No. LED Indication]
GAGE
[Display on D-EV (while the DISP key is held down)]
UNIT
+NG
GO
-NG
(3) Each time the DISP key is pressed, the current CH number
is switched, sequentially displaying the count values of
CH03 (CEL3) to CH06 (CEL6) in order.
