4 - 7
4 BASIC OPERATION
No. 99MBC034B
(4) Repeat step 3 as required to place all digits, including the
least significant digit.
[Display on the D-EV]
UNIT
+NG
GO
-NG
NOTE • If the gage resolution has been set to 5µm/0.5µm, set
the least significant digit to 0 or 5.
• Only one set of tolerance values can be set for each
CEL.
(5) While the least significant digit is flashing, press the MODE
key. The entered value is accepted and the flashing stops.
[Display on the D-EV]
UNIT
+NG
GO
-NG
(6) Press the Fn key to move to the next setup item.
The selected item will change as follows: preset value,
lower limit value, upper limit value, count value.
NOTE • Preset values and tolerance values are retained in
memory even when the power is off.
• Set a lower tolerance limit that is equal to or smaller
than the upper tolerance limit. An incorrect setting
may cause a tolerance setting error (Err90). If this oc-
curs, press the P.SET key and perform the input op-
eration again, starting with the lower tolerance limit.
• In the case of using the EV-16D, perform presetting/
tolerance limit setting with the linear gage connected,
as the connected linear gage sets the resolution auto-
matically
TIP • If the RS-232C communication function is used, a pre-
set value/tolerance value of a maximum of eight digits
can be set.
• The factory-set default preset value, lower limit value,
and upper limit value are as follows:
If a 1µm gage is used:00000.000 / -99999.999 /
99999.999
Display on D-EV: 000.000/ -F99.999/ F99.999
