Garmin 190-01120-00 Marine GPS System User Manual


  Open as PDF
of 132
 
GPSMAP
®
6000/7000 Series Owner’s Manual 91
Radar
Adjusting Crosstalk Clutter on the Radar Screen
You can reduce the appearance of clutter caused by interference from another nearby radar source.
On is the default value for the crosstalk setting.
NOTE: Depending upon the radar in use, the crosstalk setting congured for use in one radar mode
may or may not be applied to other radar modes or to the Radar Overlay (page 85).
1. From the Home screen, select
Radar.
2. Select
Cruising, Harbor, Offshore, Dual Range or Sentry mode.
3. Complete an action:
Select Menu > Noise Rejection > Crosstalk > On for Cruising, Harbor, Offshore, or Sentry
mode.
Congure the setting for both screens in Dual Range mode. Select > Menu > Noise
Rejection > Crosstalk > On for the GPSMAP 6000 series. Select Left > Noise Rejection >
Crosstalk > On for the GPSMAP 7000 series.
Radar Display Appearance
Data Bar Settings
Data bars can appear in all Radar modes, and they provide real-time, at-a-glance information.
All data bars congured for use in one radar mode appear in every other radar mode. All data bars
congured for use on the Radar Overlay appear only on the Radar Overlay, and must be congured
separately.
Showing the Cruising Data Bar on the Radar Screen
The cruising data bar shows GPS speed, GPS heading, depth, and GPS position data.
1. From the Home screen, select
Radar.
2. Select
Cruising, Harbor, or Offshore mode.
3. Select
Menu > Radar Setup > Data Bars > Cruising > On.
Conguring the Cruising Data Bar on the Radar Screen
You should show the cruising data bar before you congure it (page 91).
The cruising data bar is divided into four sections, and each section appears in a different corner of
the Radar screen. You can select the type of data that appears in each section of the data bar.
1. From the Home screen, select
Radar.
2. Select
Cruising, Harbor, or Offshore mode.
3. Select
Menu > Radar Setup > Data Bars > Cruising > Data Bar Setup.
4. Select
Top Left.
5. Select the type of data to appear in the top left section of the data bar.
6. Repeat steps 4 and 5 for the
Top Right, Bottom Left, and Bottom Right sections of the data bar.
•
•
 previous next