Filter
Top Products
5
Insert gauge through the hole in the front side of the dash (left). Slide
the rubber gasket over the cables, followed by the plastic collar (right).
Slide the gasket forward so it is flush with the back of the dash, then
screw on the mounting collar, turning it until it is snug against the
gasket and the back of the dash.
Find a buzzer location that is protected from the elements, but that
still allows you hear it. Connect the buzzer wires according to one of
the two wiring diagrams on the following page.
NOTE:
Later model LMF-200 gauges have different color wires, so examine
the wiring diagrams carefully before connecting any wires.
Use two cable ties and attach the buzzer to one or both of the cables at
the back of the gauge or use the adhesive back of the buzzer to stick it
to a flat, clean surface.
If desired, connect the dash light wires as shown in the following
figure. Finish the installation by plugging the network cable into the
network.
Wiring
The LMF-200 draws operating power from the NMEA 2000 network.
The gauge does not have an on/off switch — whenever the network has
power, the LMF-200 is on and drawing current.