Filter
Top Products
36
Devices list. To do this, let the menu time out and press
MENU.
Select
SYSTEM SETUP and press MENU. Highlight B. DEVICES and press
MENU. The Fuel Flow will be listed with its new configuration.
To configure Fuel Flow:
When you configure a fuel flow, you are linking the fuel flow's
location/engine on the boat to its matching configuration/device name
(Port, Center or Starboard) in the LMF-200.
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU. After a few moments, the Bus
Devices list will appear, showing all LowranceNet devices detected on
the network.
3. Select
UNCFG FF and press MENU, which will open the Configuration
options menu with up to three options: Port, Cen and Stbd. Select the
desired location and press
MENU. The following message will appear:
Hit Menu to Cfg Flow Sns.
NOTE:
If your unit is set to a one-engine configuration, the Configuration
Options menu will not appear when you are configuring a fuel flow.
On the Bus Devices list, the fuel flow will automatically be given
the configuration name Eng FFlow.
4. Press
MENU, which, if you have more than one EP-10 Fuel Flow, will
take you back to the configuration options menu. Configure the
remaining fuel flows by following the steps above. If you have one fuel
flow, you will be directed back to the Bus Devices list. Remember: If the
fuel flow you just configured is not shown on the Bus Devices the list,
you will have to refresh the list. Let the Bus Devices list time out, then
access it again.
To unconfigure an EP-10 Fuel Flow:
If you want to reassign a fuel flow's configuration/device name in the
LMF-200 or when you want to reconfigure an engine when all engines
on your vessel are configured, you first will have to unconfigure a fuel
flow.
Unset Engine:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU. After a few moments, the Bus
Devices list will appear, showing all LowranceNet devices detected on
the network.
3. Select the fuel flow you want to unconfigure and press
MENU.