Filter
Top Products
44
4. Press
MENU to reset the selected fluid level’s configuration and
calibration information to the default settings. You will be taken back
to the Bus Devices list where the selected fluid level will be displayed
as UnCfg FL.
WARNING:
If you reset any individual EP sensor, it will lose all
configuration and calibration settings.
Suzuki Engine Interface Configuration
The LMF-200 can support up to three engines with one engine
interface for each engine. If you have one configured engine interface, it
will be displayed as Eng Int. If you have three configured fuel flows,
they will appear as Port Eng, Cen Eng and Stbd Eng. When the
interface is unconfigured it will be shown as UnCfg Eng.
Each fuel flow has an internal menu with the following options: Unset
Engine, Change Engine. Fuel Warning, Reset and Reset Fuel
Calibration and Reset Trim Calibration.
NOTE:
If, after configuring, unconfiguring or reconfiguring an engine
interface, it is not shown on the Bus Devices list, you will have to
refresh the list. To do this, let the menu time out and press
MENU.
Select
SYSTEM SETUP and press MENU. Highlight B. DEVICES and press
MENU. The Engine Interface will be listed with its new
configuration setting.
To configure Suzuki Engine Interface:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU. The Bus Devices list will
appear.
3. Select
UNCFG ENG and press MENU. The following message will appear:
Hit Menu to Cfg Eng Int. Press
MENU.
4. The Suzuki Engine Model menu will appear with the following
options: DF40, DF50, DF60, DF70, DF90/115, DF140, DF150, DF175,
DF200/225, DF250 and DF300.
5. Select your Suzuki model engine from the list and press
MENU. The
Select Engine menu will appear with up to three options: Port, Center
and Starboard. (If you have a single-engine configuration, you will not
be taken to the Select Engine menu. You will be taken back to the main
display.)