Filter
Top Products
27
To change Volume units:
Choosing Volume from the Change Units menu will allow you to set the
unit of measure for volume to US Gallons or Liters.
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
UNITS and press MENU. Select VOLUME and press MENU,
which will open the Volume menu with two options: US gallons and
Liters.
3. Select the desired setting and press
MENU, which will take you back
to the main page.
Fuel Setup
Fuel Setup allows you to adjust options that will be used to measure
fuel economy. The following options can be set or reset from the Fuel
Setup menu: Refill Tank (Refill T), Part Fill (Partial Fill), Economy
Speed (Eco spd), Fuel Remaining Source (FRem Src), Reset Trip Fuel
(Rst trip F), Reset Seasonal Fuel (Rst Seas).
Refill Tank (Refill T)
The Refill Tank command ensures your LMF-200 fuel reading is
consistent with the actual amount of fuel in your tank or tanks. Refill
Tank must be used with the EP-10 Fuel Flow, EP-50 Storage Device
and the Suzuki NMEA 2000 Engine Interface. The Refill Tank
command is NOT used when the EP-15 Fluid Level is used to read the
fuel level.
To refill tank:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU. Highlight FUEL MNGR and press MENU.
2. Select
REFILL T and press MENU. The following message will appear:
Hit Menu if Tank filled up.
3. If the tank has been filled, press
MENU, which will take you back to
the main display.
NOTE:
If an EP-10 Fuel Flow or a Suzuki Engine Interface is being used a,
menu will appear giving you the option to calibrate fuel
calculations. We will discuss calibration in Section 4: Configuration
and Calibration.
Partial Fill (Part Fill)
The Partial Fill command helps maintain the accuracy of fuel economy
by allowing you to input the amount of fuel you added to your tank or
tanks. The Partial Fill command can be used with the EP-10 Fuel Flow,
EP-50 Storage Device and the Suzuki NMEA 2000 Engine Interface.