Filter
Top Products
34
3. Highlight
UNCFG TEMP and press MENU. The following message will
appear: Hit Menu to Cfg Temp Sns.
4. Press
MENU to be taken to the Selecting Temp menu, which will have
three options: Inside, Outside and Water.
5. Highlight one of the Temp options and press
MENU. The temp sensor
has now has been configured. You will automatically be directed to the
Bus Devices list.
To unconfigure EP-35 temp sensor:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU, which will open the Bus Devices
list.
3. Select a temp sensor from the Bus Devices list and press
MENU. The
Configuration Options menu will appear with two choices: Unconfig
(Unconfigure) and Reconfig (Reconfigure).
4. Select
UNCONFIG and press MENU. The following message will appear:
Hit Menu to Unset Device Name.
5. Press
MENU to unconfigure the sensor and be directed back to the
Bus Devices list, where the temp you unconfigured will be listed as
Uncfg Temp.
To reconfigure an EP-35 temp sensor:
To reconfigure a sensor, there must be a configuration name available
(Water, Outside or Inside. In the following example, there are three
configured temps, one each for inside, outside and water temp. If you
try to reconfigure a sensor when the desired configuration name
(Water, Outside and Inside) is in use, a Name Already Selected message
will appear.
If all three temps are configured, which means there is no name
configuration available, follow the first set of instructions. If the desired
configuration name is available, follow the second set of instructions.
The steps below will show you how to switch the configuration of a
water temp to an outside temp.
If all temps configured (Configuration name unavailable):
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU, which will open the Bus Devices
list.
3. Highlight
WTR TEMP on the Bus Devices list and press MENU, which
will launch the Configuration Options menu.