Filter
Top Products
28
To use Partial Fill:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU. Highlight FUEL MNGR and press MENU.
2. Highlight PART FILL and press MENU. The Select Tank menu will
appear with up to three options: Port, Center and Starboard. (If you
have one tank, you will be taken directly to the Fuel Quantity window.)
Select the desired engine and press
MENU.
NOTE:
When using the Partial Fill command, you will only be able to input
an amount of fuel less or equal to the fuel used figure. The unit will
not allow you to input a fuel amount greater than the fuel used
figure.
3. The Fuel Quantity window will appear. Use the
UP and DOWN keys
to enter the amount of fuel you added to the tank and press
MENU. You
will be taken back to the main display.
Economy Speed (Eco spd)
The Economy Speed menu allows you to choose what speed source the
LMF-400 will use to calculate Fuel Economy. A NMEA 2000 GPS
module, like the LGC-2000, measures ground speed The EP-25
Paddlewheel and NMEA 2000 Pitot Tube measure water speed.
NOTE:
Ground Speed is the default speed source for Fuel Economy.
To change Economy Speed Source:
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU. Select FUEL MNGR and press MENU.
2. Highlight
ECO SPD and press MENU, which will open the Eco spd
menu. The menu has three options: Water Spd (Water Speed), Pitot
Speed and Gnd Spd (Ground Speed). A NMEA 2000 GPS module
measures ground speed, while a paddlewheel, like the EP-25 measures
water speed.
3. Select the desired speed source and press
MENU, which will take you
back to the main display.
Fuel Remaining Source (FRem Src)
The Fuel Remaining source function allows you to select the device
used to measure the amount the fuel remaining in the tank.
NOTE:
If you plan to use a fluid level sensor for a fuel tank, you must
switch the fuel remaining source to Fuel Level. If you want to use
the EP-10 Fuel Flow, EP-50 Storage Device or the NMEA 2000
Suzuki Engine Interface to measure fuel remaining, select
Engine/FFlow from the Fuel Remaining Source menu.